National-instruments Quadrature Input Module FP-QUAD-510 Manual do Utilizador

FieldPoint™, National Instruments™, and ni.com™ are trademarks of National Instruments Corporation. Product and company names mentioned herein are tra

FP-QUAD-510 10 www.ni.com• As with any hazardous voltage wiring, make sure that all wiring and connections meet applicable electrical codes and common

© National Instruments Corp. 11 FP-QUAD-510SpecificationsThe following specifications are typical for a range of –40 to +70 °C, unless otherwise noted

CE Mark ComplianceThis product meets applicable EU directive(s), as follows:Safety isolation ...EN 61010 (double insulat

FP-QUAD-510 2 www.ni.comWhen defining a FieldPoint system that uses an FP-QUAD-510 module, you must calculate the power consumption. First refer to th

© National Instruments Corp. 3 FP-QUAD-510Figure 1. Install Your ModuleField WiringThe terminal base provides connections for each axis and for an ex

FP-QUAD-510 4 www.ni.comFigure 3. Basic Field Connections to Single-Ended EncodersThe FP-QUAD-510 supports differential inputs for Phase A, Phase B,

© National Instruments Corp. 5 FP-QUAD-510Terminal assignments and wiring diagrams are also listed under the slide-in card on the front of the FP-QUAD

FP-QUAD-510 6 www.ni.comPosition Counter OperationEach position counter has a 32-bit binary counter that represents the current position of the shaft

© National Instruments Corp. 7 FP-QUAD-510Reset on Index CapabilityYou can configure each position counter to reset each time the index condition is m

FP-QUAD-510 8 www.ni.comThe velocity range is the maximum velocity that can be measured for a given timebase. The velocity register uses a 15-bit coun

© National Instruments Corp. 9 FP-QUAD-510NoteIf the axis is stopped with the index condition true, then reading the status bit causes the bit to rese